Warranty 4 years !
Warning: Last items in stock!
Availability date: 2017-07-18
By buying this product you can collect up to 6 loyalty points. Your cart will total 6 loyalty points that can be converted into a voucher of 1,02 €.
FGR-222 module Z-Wave device from Fibaro , which allows control of any installation with an ac motor.It also allows a control by wall switch.
The module Z-Wave of Fibaro FGR-222 allows precision control of the mechanical engines, as well as the end of the race of all system, in particular, the motion systems at the end of the race electronics.
This module works with the neutral!
The module FGR-222 is capable of transmitting the power consumption instant (W) and cumulative (KWh) of
Order your blinds or shutters remotely
Compatible with OSI and venetian blind with positioning of the slats
Installs behind existing switch
According to ascent/descent and positioning
Compatible with the motors to stop mechanical or electronic
Terminal blocks for greater wiring convenience
Rounded shape to meet the most stringent standards
Measurement of the instantaneous fuel consumption, and cumulative
Wireless update with the box, Fibaro Home Center 2
Function test coverage Z-Wave network
Small, discrete and aesthetic
Ease of use and installation
Type of module : Receiver Z-Wave
Power supply : 110 - 240V~, 50/60Hz
Power consumption : < 0.8 W
Wiring : 3-wire, neutral required
Max load :
4.2 A for resistive loads
1.7 A for motors with compensated power factor (inductive loads)
Frequency : 868,42 Mhz
Signal power : 1mW
Transmission Distance : 50m free field, 30 m indoors
Dimensions: 20 x 42 x 38 mm
Operating temperature : 0-40°C
Temperature limit : 105°C
EMC DIRECTIVE 2004/108/EC
R&TTE DIRECTIVE 1999/5/EC
The adapter Eutonomy euFIX R222NP is used to install the module Fibaro® Switch FGR-222 or FGRM-222 on a rail of type DIN TH35 in the electrical panel.
The adapter Eutonomy euFIX R222NP consists of a housing and an electronic card, on which the Switch module FGR-222 or FGRM-222 is mounted.
The dimensions of the case are appropriate for a standard rail DIN TH35/TS35.
The e-card contains a set of screw terminals, where all the wires (power, signal input and output, command buttons) can be connected safely.
Adapter DIN to Fibaro Switch FGR-222 or FGRM-222 without push buttons
Used to install the module Fibaro Switch FGR-222 or FGRM-222 on the din rail of type DIN-TH35 / TS35 in the electrical panel
Location free on the label to identify the line controlled
Supply voltage: 230 V AC +/- 10%, 50-60Hz
Power load: max 6.5 A per channel, 10A total
Dimensions: 34,8 x 87,3 x 64,7 mm
Width in units TE: 2 TE coolers
Cross Section of the conductor of wire : max. 2.5 mm2
Maximum length of the wires connected to the inputs Sx, S1, S2: 20m
Operating temperature: 0 ° C to +50 ° C
Relative humidity: ≤90%, no condensation
LVD 2014/35 / EC
RoHS 2011/65 / EU
No customer reviews for the moment.