Jack ordered and consomètre Z-Wave Plus with 2 USB ports, Hank

The smart plug Hank HKZW-SO05 is a module Z-Wave More

The smart plug Hank HKZW-SO05 is a module, Z-Wave Plus, which just installs between the device to control and a wall outlet.

The smart plug Hank HKZW-SO05 can be controlled in on/off mode any type of electrical device or the lighting since its button located locally, or from any Z-Wave controller compatible.

The smart plug Hank HKZW-SO05 intégret also, the measurement function of consumption, this decision could indicate the consumption in watts or energy use in kWh Z-Wave controller.

The level of consumption of the connected load will be indicated visually by the RGB LED built-in, creating a ring of light.

These RGB LED can also indicate the quality of the signal between the plug and the Z-Wave controller when using the test function of range Z-Wave.

The smart plug Z-Wave Plus Hank is equipped with 2 USB ports (1A and 2.4 A), which allow you to recharge smartphones or tablets.

This module Z-Wave also functions as a wireless repeater with the other modules, in order to ensure a total coverage of your dwelling. A Z-Wave controller (remote control, dongle, etc.) is necessary in order to integrate this module into your network if you already have an existing network.

Features smart plug Hank HKZW-SO05 :

• To order a lamp or a remote device

• Module taken will be integrating directly between a power outlet and the load order

• Function ON / OFF to control the lamps or appliances (no change)

• Measurement of the instantaneous fuel consumption, and cumulative

• Control the load locally via the integrated button

• 2 USB ports to charge smartphones or tablets

• Test function of range Z-Wave

• Indicates in real time the consumption, thanks to its ring of light (7 levels of color)

• Overload Protection

• Safety radio communication via AES-128 encryption

• Integrates the chip Z-Wave 500 series

• Updates to the firmware Over The Air (OTA)

• Repeater messages to Z-Wave

• Ease of use and installation

• Power supply : 230VAC, 50Hz

• Standby power consumption : 1.5 W

• Max load : 2300W / 10A

• USB outputs : DC 5V±5%, 1A (Port1), 2.4 A (Port2)

• Frequency : 868,42 Mhz

• Transmission Distance : 150m in free field, 40m indoor

• Dimensions : 82 x 55 x 28 mm

• Operating temperature : -10°C to 40°C

• Certifications: FCC, CE, Z-Wave

• N° certification Z-Wave : ZC10-16075153