Z-wave switch finish Everlux to order a circuit-mode variation.
Switch DUWI 05433 in the firmware changed.
Features:
- Control your lighting remotely
- Installed in place of an existing switch
- Dimmer
- Switching time On/Off configurable
- Time to change configurable
- A better compatibility with the box domotique Z-Wave (Vera, eedomus...)
- The change of the module state is immediately transmitted to the Z-Wave controller
- Possibility to use the switch to drive locally or to trigger scenes on the controller (single click, double click, change of status)
- Use the latest firmware Z-Wave for a better management of the inclusion of modules and automatic reconfiguration of the network
- Algorithm routing improved for faster communication
- Improvement of the "Nodes ghosts" in the event of a reset of the controller
- Comes complete with trim frame and button of the range Düwi Everlux
- Type of module : Receiver Z-Wave
- Power supply : 230V, 50 Hz
- Wiring : 2-wire, no neutral required
- Maximum load :
- Incandescent lamps : 40...300W
- Halogen lamps : 40 ... 300W
- Low-voltage halogen lamps (inductive load): 30...300VA
- Dimmable fluorescent lamps : 30... 300VA
- Fuse : T 1.25 A H
- Frequency : 868,42 Mhz
- Distance : 30m indoor
- Dimensions: 52mm x 52mm x 31mm
- Operating temperature : 0-40°C