FIBARO - command Button,...
The FIBARO Button FGPB-101 allows you to control the devices from your Z-Wave network and perform various
scenes defined in the system FIBARO.
Color white.
(à modifier dans le module "Réassurance")
(à modifier dans le module "Réassurance")
(à modifier dans le module "Réassurance")
The adapter Eutonomy euFIX D212 is used to install the module Fibaro® Switch FGD-212 on a rail of type DIN TH35 in the electrical panel.
The adapter Eutonomy euFIX D212 consists of a housing and an electronic card, on which the Switch module FGD-212 on a rail of type DIN TH35 in the electrical panel.is mounted.
The dimensions of the case are appropriate for a standard rail DIN TH35/TS35.
The e-card contains a set of screw terminals, where all the wires (power, signal input and output, command buttons) can be connected safely.
The front panel of the case contains two micro-buttons of diagnosis S1 and S2, which can be used to control the module, save the module in the Z-Wave system or remove it from the system without opening the housing of the adapter.
Adapter DIN to Fibaro Switch FGD-212 on a rail of type DIN TH35 in the electrical panel. without push buttons
Used to install the module Fibaro Switch FGD-212 on a rail of type DIN TH35 in the electrical panel. rail of type DIN-TH35 / TS35 in the electrical panel
Location free on the label to identify the line controlled
Supply voltage: 230 V AC +/- 10%, 50-60Hz
Power load: max 6.5 A per channel, 10A total
Dimensions: 34,8 x 87,3 x 64,7 mm
Width in units TE: 2 TE coolers
Cross Section of the conductor of wire : max. 2.5 mm2
Maximum length of the wires connected to the inputs Sx, S1, S2: 20m
Operating temperature: 0 ° C to +50 ° C
Relative humidity: ≤90%, no condensation
Guidelines:
LVD 2014/35 / EC
RoHS 2011/65 / EU