Dualtech TS100 - PSTN emergency IP GSM transmitter

Dualtech TS100 PSTN backup IP GSM dialer

The TS100 manages the telephone line connected to a dialer and, if necessary, provides a different channel via a GSM network: placed between the dialer and the telephone network, it routes the call via the GSM in the event of a line break.

The TS100 can also transmit the line cut information by an SMS message. The TS100 is equipped with a GSM modem which must be equipped with a SIM card with an analogue subscription (normal).

The TS100 is compatible with most commercial transmitters.

The receiving bays do not have to be modified.

New functions:

• Dual band 900/1800 MHz

• GSM cycle test • Remote output

• Programming by telephone

• Built-in real-time clock

• Read programming remotely

The TS100 monitors the state of the telephone line and immediately provides a communication path via the GSM network in the event of a line fault.

The TS100 is very easy to install and can be connected to any type of alarm system. It is compatible with most receiver bays.

In normal situation, the alarm transmitter is connected to the PSTN network.

It is via the public network line that the alarm messages are transferred to the central monitoring station.

In the event of a PSTN line cut, the transmitter is connected to the GSM modem of the TS100: calls from the transmitter are directed to the GSM.

The TS100 constantly monitors the state of the PSTN line and, in the event of a fault, generates information that can trigger the transmitter.

The call will be routed through the GSM network.

In addition, the TS100 continuously monitors the quality of the GSM network connection. If the signal drops, a fault output is activated. All of the programming, contained in the SIM card, is carried out using a mobile phone.

The TS100 can also transmit SMS messages.

Features of the Dualtech TS100:

STARTERS:

• "PSTN Input": PTT line
• "SW/AL Input: Trigger a pre-programmed SMS message or switch to the GSM network
• "Supply Input": 12 VDC power supply (10-25 VDC)

EXITS

• "Supply Output": 12 VDC output
• "GSM Output": Direct access to the GSM channel of the TS100 by a telephone handset
• "Line Output": Line output to an alarm transmitter.
• "PSTN Error": Line fault output. Appearance or disappearance of OV
• "GSM Error": GSM fault output Appearance or disappearance of OV
• "Tamper Output": Tamper "O/C OUT": Remote output Appearance or disappearance of OV

SETTINGS (Configuration Switch)

• DIP1&2: RTC fault delay programming
• DIP3&4: Programming GSM fault delay
• DIP5: Max. call delay. on GSM (unlimited / 10 minutes)
• DIP6: Alarm outputs in NC/NO
• DIP7: Switch table mode (the TS100 ignores the 1st dialed digit)
• DIP8: Normal LED indication / LED indicates GSM network signal strength GSM antenna positioning adjustment mode where TS100 ignores 2nd digit dialed • Power supply: 10-25 VDC. • Presented in a white metal case • Consumption: 200 mA at rest • Supplied with 1 antenna – remote In GSM transmission: approximately 350 mA + 2 meter cable