Paradox R910 - badge reader
Paradox R910 badge reader
Our e-commerce site is secured by SSL
Free delivery from €100 to Relay points with Mondial Relay or DPD
You have 14 days to withdraw
Paradox R910 badge reader
Badge reader for Paradox alarm system
Three-color LED display
The R910 reader includes a three-color LED display (red, green, and amber) used to indicate reader status. The intensity of the LEDs is adjusted using the Access Control Module (ACM).
Audible tone
The R910 reader includes a built-in buzzer whose frequency is adjusted using the Access Control Module (ACM).
weather resistant
Indoor or outdoor installation.
Display of errors
All R910 readers display communication errors between reader and Module (ACM) by flashing amber LED
each second.
Firmware upgrade
Connect the CV4USB as shown in Figure 2. Refer to the CV4USB installation manual for more information.
Mounting on a metal surface
Metal can cause a decrease in read range. It is possible to mount the R910 card reader on a metal surface,
but do not surround it with metal. If the reader is to be installed in a metal enclosure, ensure that the front of the card reader is not covered and that a space of at least 4 cm (1.6 in) is left between the card reader and metal on each side.
Characteristics of the R 910 badge reader :
-
Input voltage : 11 VDC at 14.5 VDC
-
Current consumption: 100 mA, 115 mA with card
-
Frequency: Exciter field - modulated by
-
125 kHz pulses
-
Operating Temperature: -35°C (-31°F) to +65°C (149°F)
-
Output formats: RS-485
-
Cable length: 300 m (1000 ft)
-
Cables: 4-wire cables
-
(recommended: twisted pairs)
-
Compatibility: Serial Access Control Module (ACM)
-
Metal box (optional) Minimum 20 x 25.5 x 7.6 cm
-
(8 x 10 x 3 in) metal box
-
Dimensions 14 x 9.2 x 2.5 cm (5.5 x 3.6 x 1 inch)