Visonic PowerMaster...
Visonic PowerMaster MC-302E-PG2 - Visonic Opening Detector
Aperture detector with wired input MC-302 E PG2 NFA2P
Our e-commerce site is secured by SSL
Free delivery from €100 to Relay points with Mondial Relay or DPD
You have 14 days to withdraw
The Optex HX-80NRAM detectors are mounted at a height of between 2.5 and 3m and provide close volumetric outdoor intrusion detection up to 24m.
The Optex HX-80NRAM detector has been designed to differentiate between humans and small to medium sized animals, greatly reducing the risk of false alarms. The HX-80NRAM is a battery-powered model with active infrared anti-masking function.
In order to adapt to the slope of the terrain, the stand of the HX-80N can be horizontally rotated 180 degrees and can be tilted up or down. With built-in shutters and plates, the HX-80N can easily be configured to mask short or long distance detection areas to focus only on the area of interest.
If the HX-80NRAM sensor is painted over, covered or obstructed, whether enabled or disabled, the active infrared anti-masking function will be able to detect the threat upon activation of the alarm system and then send a notification.
The HX-80NRAM can be powered by various universal batteries, including CR123, CR2 and 1/2 AA (not included). Its housing can accommodate most commercially available wireless radio transmitters. The detector is thus easy to install on remote or temporary sites.
Detection method Passive infrared
PIR coverage 24.0m × 2.0m (80' × 6'7") wide/20 zones
PIR Limit Distances 6.5m, 10.0m, 13.0m, 18.0m (22', 33', 42', 59')
Detectable speed 0.3 m/s – 1.5 m/s (1'/s – 4'11"/s)
Sensitivity 2.0°C (3.6°F) at 0.6 m/s
Power supply 3 – 7.2 V DC Lithium battery (CR123A × 3, CR2 × 3, 1/2AA × 3, 1/2AA × 6)
Operating voltage 2.5 – 9 V DC
Current consumption 30 μ A (in stand-by) / 4 mA (max.) at 3 V DC
Alarm period 2.0 plus/minus 1.0 sec.
Heating period Approx. 90 sec. (LED flashes)
Alarm output Form C dry contact 10 V DC 0.01A (max.)
Fault output NC/NO Semiconductor switch selectable 10 V DC 0.01 A (max.)
Tamper output Form C dry contact Semiconductor switch 10 V DC 0.01A (max.)
LED Indications On: When DIP Switch 1 (WALK TEST MODE) or DIP Switch 4 (LED) is ON Off: Normal Operation On/Flashing: Ready, Alarm, Fault, Low Battery RF Interference No alarm 10 V/m
Operating temperature -20 – +60°C (-4 – +140°F)
Humidity 95% max.
IP55 sealing
Wall Mount
Mounting height 2.5 – 3.0 m (8'2" – 9'10")
Ball head adjustment Vertical: ±20° Horizontal: ±95° Weight 780 g (27.5 oz.) Accessories Ball head, Screws (4 × 20 mm) × 4, Velcro strips × 2, Alarm cable, Battery wires × 2, Dummy Battery