Z-WAVE.ME switch shutter

Z-wave switch finish Everlux to order roller shutters.

Switch DUWI 05459 in the firmware changed.

Features:

• Time of opening and closing configurable (the time are usually different due to gravity) allows the use of panes with stops on electronic and mechanical.
• A device can be used to block the use of the component, such as an opening sensor
• Better compatibility with the box domotique Z-Wave (Vera, eedomus...) that the model Duwi
• The change of the module state is immediately transmitted to the Z-Wave controller
• It is possible to use the switch to drive locally or to trigger scenes on the controller (single click, double click, change of status)
• This module uses the latest firmware Z-Wave for a better management of the inclusion of modules and automatic reconfiguration of the network and an algorithm of routing improved for a faster communication.
• Improvement of the "Nodes ghosts" in the event of a reset of the controller.

• Comes complete with trim frame and button of the range Düwi DURO 2000
• Type of module : Receiver Z-Wave
• Power supply : 230V, 50 Hz
• Wiring : 3-wire, neutral required
• Maximum load : motor 1800W
• Maximum duration of the signal : 2 min.
• Fuse : T 8 A H
• Frequency : 868,42 Mhz
• Distance : 30m indoors (varies according to many parameters, see this article)
• Dimensions: 52mm x 52mm x 31mm
• Operating temperature : 0-40°C
• This module requires a Z-Wave controller to work (box home automation, USB dongle Z-Wave + software, etc).